I’m curious, when you make fusible applique and the pattern tells you to trace 3 or 6 or 15 of an applique shape, do you really do that???
Do you trace any shape more than once?
If so, my next question is “Why?”
It occurred to me several years ago that I’m lazy & I like to get things done quickly so I can move onto the next project.
What occurred to me later is that not everyone thinks like I do. (Thank goodness!!!)
I never, never, NEVER trace a shape more than once, and I really don’t like to trace it even once.
How slow, boring and a waste of time!
When I have more than one of the same shape to cut out,
I fetch my bolt of Wonder Under.
Next, I calculate what I need.
If the object is about 6″ square (I’ve added about 1/4″ all around the object) and I need 6 of them, I will cut a 6″ x 36″ piece(s) of fusible web.
I also cut a 6″ strip of the fabric I’m going to use.
If I need to piece the Wonder Under, I just butt the edges together.
It doesn’t show if you have nice straight lines cut of the Wonder Under.
Let the piece cool,
then remove the paper backing by scoring it with a pin & pulling it off.
Next, cut the “fused slab” into however many of the size shapes you need.
It is CRITICAL that you stack up the pieces all the same way, fabric to fusible web
NOT fusible web to fusible web.
If you cut out your shape that way,
you will have one nice double-sided object.
You will most probably NEVER get those two shapes apart again.
Ask me how I know!!!
On the other hand, if you need a right and a left (reversed) object,
I recommend leaving the paper on and stacking paper to paper
then cut out the shape and you’ll have mirror objects, both cut at once!
6 jacks with one fast cutting with my rotary cutter and rotating mat!
One more tidbit of info…
If your pattern is already reversed for you as in my
Suzn Quilts’ Patterns,
you will need to pay attention to which side you lay the pattern on before you cut it.
You don’t want to accidentally cut out the shape in reverse.
When I’m working on a new pattern like this one,
I don’t reverse the shape until I put it into pattern form,
so I put the shape on the fabric side of the stack.
If the shape is reversed for you, just put the pattern on the fusible web side of the stack, then cut.
By the way, this new design that I’m working on also has 7 big circles.
You may say I can’t cut out circles with my rotary cutter…
but I just did!
hold the ruler tightly down on the stack,
holding it right at the edge where you need to cut.
You’ll need to keep all the layers tightly held together and cut smoothly.
When you stop to re-grip, leave the cutter in place.
Yes, I have a circle cutter, but for this instance, this is quicker.
Steady hand and close to the ruler!
Until next time,